Journal of Central South University

An improved joint method for onset picking of acoustic emission signals with noise

A novel sparse filtering approach based on time-frequency feature extraction and softmax regression for intelligent fault diagnosis under different speeds

Parameter optimization for improved aerodynamic performance of louver-type wind barrier for train-bridge system

Hybrid ToA and IMU indoor localization system by various algorithms

Peristalsis of nanofluid through curved channel with Hall and Ohmic heating effects

Impulsive component extraction using shift-invariant dictionary learning and its application to gear-box bearing early fault diagnosis

Probabilistic seismic stability of three-dimensional slopes by pseudo-dynamic approach

Three-dimensional analysis of natural convection in nanofluid-filled parallelogrammic enclosure opened from top and heated with square heater

Effect of gene dosage and incubation temperature on production of β-mannanase by recombinant Pichia pastoris

Numerical simulation of heat release performance of filling body under condition of heat extracted by fluid flowing in buried tube

Mechanical behaviour analysis and support system field experiment of confined concrete arches

Transient analysis of Casson fluid thermo-convection from a vertical cylinder embedded in a porous medium: Entropy generation and thermal energy transfer visualization

An adaptive electrical resistance tomography sensor with flow pattern recognition capability

Equilibrium concentration of lithium ion in sodium aluminate solution

Tribological properties of Fe(Cr)-B alloys at high temperature

Parameters estimate of recurrent quantum stochastic filter for time variant frequency periodic signals

Treatment of bauxite residue dust pollution by improving structural stability via application of synthetic and natural polymers

Flow characteristics at low Reynolds number around two in-line circular cylinders with slits

A new approach for on-line open-circuit fault diagnosis of inverters based on current trajectory

Influence of AZ31 sheet treated by cryogenic on punch shearing

Upper bound solution of surrounding rock pressure of shallow tunnel under nonlinear failure criterion

Integrated yaw and rollover control based on differential braking for off-road vehicles with mechanical elastic wheel

Tunnel face reliability analysis using active learning Kriging model—Case of a two-layer soils

Collecting performance of vegetable oils in scheelite flotation and differential analysis

An enhanced image binarization method incorporating with Monte-Carlo simulation

Modeling of goethite iron precipitation process based on time-delay fuzzy gray cognitive network

Adsorption kinetics and thermodynamics of sodium butyl xanthate onto bornite in flotation

OMHT method for weak signal processing of GPR and its application in identification of concrete micro-crack

Effect of composition and aging time on hardness and wear behavior of Cu-Ni-Sn spinodal alloy

Dynamic change and diagnosis of physical, chemical and biological properties in bauxite residue disposal areas

Gas-liquid mass transfer of carbon dioxide capture by magnesium hydroxide slurry in a bubble column reactor

Numerical study of effect of front cavity on hydrogen/air premixed combustion in a micro-combustion chamber

Soft measurement model on torque of alternating current electrical dynamometer including copper loss and iron loss

Experimental investigation on combustion and unregulated emission characteristics of butanol-isomer/gasoline blends

Salt ions accumulation and distribution characteristics of pioneer plant species at a bauxite residue disposal area, China

Stability analysis for nonhomogeneous slopes subjected to water drawdown

Surface water quality and potential health risk assessments in Changsha-Zhuzhou-Xiangtan section of Xiangjiang River, China

Factors affecting thin coal seam shearer drum coal-loading performance by a model test method

Inverse Stone-Thrower-Wales defect and transport properties of 9AGNR double-gate graphene nanoribbon FETs

Quantitative analysis on influencing factors for interface propagation-based thermal conductivity measurement method during solid-liquid transition

Bio-derived N-doped porous carbon as sulfur hosts for high performance lithium sulfur batteries

Dropwise condensation heat transfer enhancement on surfaces micro/nano structured by a two-step electrodeposition process

Demodulation spectrum analysis for multi-fault diagnosis of rolling bearing via chirplet path pursuit

Effect of crack-closure treatment on fatigue durability of cracked rib-to-deck welded joints in steel bridge decks

Coupling effect of evaporation and condensation processes of organic Rankine cycle for geothermal power generation improvement

Role of matrix structure and flaw size distribution modification on deflection hardening behavior of polyvinyl alcohol fiber reinforced engineered cementitious composites (PVA-ECC)

Nested Newmark model to estimate permanent displacement of seismic slopes with tensile strength cut-off