INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

Entropy generation rate minimization for hydrocarbon synthesis reactor from carbon dioxide and hydrogen

Experimental investigation on thermal performance of phase change material coupled with three-dimensional oscillating heat pipe (PCM/3D-OHP) for thermal management application

Non-linear radiative heat transfer analysis during the flow of Carreau nanofluid due to wedge-geometry: A revised model

Bénard-Marangoni instability in sessile droplet evaporating at constant contact angle mode on heated substrate

The combined effect of wall shear stress topology and magnitude on cardiovascular mass transport

Investigation on the effects of narrowed channel cross-sections on the heat transfer performance of a wavy-channeled PCHE

Microscale interaction between laser and metal powder in powder-bed additive manufacturing: Conduction mode versus keyhole mode

Single-phase thermal and hydraulic performance of embedded silicon micro-pin fin heat sinks using R245fa

Large eddy simulation analysis of the heat transfer enhancement using self-oscillating fluidic oscillators

Numerical simulation of enhancing shale gas recovery using electrical resistance heating method

Temperature-responsive thermal metamaterials enabled by modular design of thermally tunable unit cells

Entropy generation analysis of wet-steam flow with variation of expansion rate using NURBS-based meshing technique

Temperature and performance modeling of thermoelectric generators

Experimental comparison of the heat transfer of supercritical R134a in a micro-fin tube and a smooth tube

Application of a non-stationary method in determination of the thermal properties of radiation shielding concrete with heavy and hydrous aggregate

Forced convection steam-water experimental database in a vertical annulus with local measurements

Modeling the confined fluid flow in micro-nanoporous media under geological temperature and pressure

A numerical analysis of unsteady transport phenomena in a Direct Internal Reforming Solid Oxide Fuel Cell

Computational study of film cooling and flowfields on a stepped vane endwall with a row of cylindrical hole and interrupted slot injections

Bilayer thermal harvesters for concentrating temperature distribution

Synthetic jet vortex rings impinging onto a porous wall: Reynolds number effect

Thermal conductivity measurements and modeling of ceramic fiber insulation materials

Numerical investigation of passive scalar transport and mixing in a turbulent unconfined coaxial swirling jet

Influence of gas compressibility on gas flow through bed of granular phase change material

Ice formation modes during flow freezing in a small cylindrical channel

Interface diffusion-induced phonon localization in two-dimensional lateral heterostructures

An experimental study of flow boiling from downward-facing heated wall in inclined channels

Philosophy of longwall goaf inertisation for coal self-heating control, proactive or reactive?

Thermal radiation and conduction in functionally graded thermal barrier coatings. Part II: Experimental thermal conductivities and heat transfer modeling

Condensation heat and mass transfer of steam with non-condensable gases outside a horizontal tube under free convection

Leidenfrost point and droplet dynamics on heated micropillar array surface

A criterion for the effect of parallel mode rotation on non- isothermal flow through square channel

Determination of diffusion coefficient of a miscible CO2/n-hexadecane system with Dynamic Pendant Drop Volume Analysis (DPDVA) technique

Discovering the active subspace for efficient UQ of molecular dynamics simulations of phonon transport in silicon

Experimental investigation on interfacial behavior and its associated pressure oscillation in steam jet condensation in subcooled water flow

Analysis of the heat transfer in the asynchronous intermittent laminar flow for mini channels in the recuperator for micro swing engines

Investigation of heat transfer performance of various insulating materials for robots

Direct numerical simulation and in-depth analysis of thermal turbulence in square annular duct

An equilibrium wall model for reacting turbulent flows with heat transfer

CFD modeling of a compact reactor for methanol synthesis: Maximizing productivity with increased thermal controllability

An improved WSGG model for exhaust gases of aero engines within broader ranges of temperature and pressure variations

Experimental study of molten tin sulfide thermal conduction

Conduction heat transfer from oblate spheroids and bispheres

A power-law liquid food flowing through an uneven channel with non-uniform suction/injection

Radiation heat transfer in a gas slab with properties characteristics of a jet engine combustor

Reduction of flow oscillation of natural circulation in non-inertial system

A pragmatic approach for simulating the fluid flow and heat transfer within industrial evaporator vessels