Tribology-Materials Surfaces & Interfaces

Feasibility study of micro-groove cross hatched surface texturing on Ti6Al4V for improved biotribological performance in metal-on-polymer hip implant

Effect of additives on a surface textured piston ring–cylinder liner system

Dry sliding wear behaviour of in-situ fabricated TiC particulate reinforced AA6061 aluminium alloy

Tribological characteristic evaluation of coconut oil dispersed with surfactant modified ceria-zirconia hybrid nanoparticles

On the role of sliding load and heat input conditions in friction stir processing on tribology of aluminium alloy–alumina surface composites

Role of zirconium diboride particles on microstructure and wear behaviour of AA7075 in situ aluminium matrix composites at elevated temperature

The study on the properties of TiCxN1−x coatings processed by cathodic arc physical vapour deposition

Dry sliding wear behaviour of Ti–6Al–4V pin against SS316L disc in vacuum condition at high temperature

A friction and wear study of laboratory aged engine oil in the presence of diesel fuel and oxymethylene ether

A review of acoustic emission as a biotribological diagnostic tool

The microstructure and wear behaviour of friction stir processed AISI 430 ferritic stainless steel

Corrosion and tribocorrosion study of 316L steel, Ti–6Al–4V and Ti–10Zr–10Nb–5Ta

The effects of contact configuration and coating morphology on the tribological behaviour of tetrahedral amorphous diamond-like carbon (ta-C DLC) coatings under boundary lubrication

Evolution of ultrafine precipitates and its influence on wear mechanism in cryoprocessed high nitrogen martensitic steel

The influence of strain hardening on steel erosion wear studied by analytical modelling of impeller testing

Influence of MoS2 and PTFE in oil film characteristics and tribological performance in EHL point contacts

Embeddability behaviour of some Pb-free engine bearing materials in the presence of abrasive particles in engine oil

The influence of surface roughness on material dislocation of microindentation using bonded interface technique

Development of a high-quality rare earth oxide modified resin-based brake material

Erosion of metals using angular silicon carbide particles

Comparative characteristics of hydrostatic conical hole-entry journal bearing with CFV, orifice and capillary restrictors